RIR Calculator - Reps in Reserve to RPE Conversion
Convert between Reps in Reserve (RIR) and Rate of Perceived Exertion (RPE) for accurate autoregulation training.
RIR Calculator
Convert between Reps in Reserve (RIR) and Rate of Perceived Exertion (RPE).
Select RPE
Reps in Reserve
RPE 8 equals
2
reps in reserve
Training Application:
Could do exactly 2 more reps
Quick Reference
What Is RIR?
RIR (Reps in Reserve) measures how many additional reps you could perform before reaching technical failure. It's a direct, intuitive metric that many lifters find easier to assess than RPE, especially when first learning autoregulation.
For example, if you complete a set of 5 reps and feel you could do exactly 2 more reps with good form, you performed that set at 2 RIR. This system removes the abstraction of rating "effort" and focuses on a concrete, countable metric.
RPE (Rate of Perceived Exertion) is Mike Tuchscherer's 1-10 scale that corresponds directly to RIR. An RPE 8 means 2 RIR, RPE 9 means 1 RIR, and RPE 10 means 0 RIR (maximum effort). The two systems are mathematically equivalent, and this calculator allows instant conversion between them.
How to Use This Calculator
Two simple conversion modes for instant results.
Choose your conversion mode
Select "RPE → RIR" to convert an RPE rating to reps in reserve, or "RIR → RPE" to convert reps in reserve to an RPE rating.
Select your value
Click the RPE or RIR value you want to convert. The calculator instantly shows the equivalent value in the opposite system.
View training guidance
Each conversion includes a description of what the rating means and how to apply it in training. Use the reference table to compare all values.
RIR vs RPE: Which to Use?
Both systems are valid — choose based on your preference.
Use RIR When:
- •You're new to autoregulation and want a concrete metric
- •You prefer counting reps over rating effort
- •Your coach programs using RIR notation
- •You find it easier to assess "how many more reps"
Use RPE When:
- •Your program is written in RPE notation
- •You're familiar with the Tuchscherer/RTS system
- •You want half-point precision (RPE 8.5, 7.5, etc.)
- •You prefer the 1-10 scale for logging
